Once
the calculation has been performed, you can select the most important
lighting engineering results for all the measurement ranges in the
Result
symbol bar
and have these displayed. The full range of outputs for the tunnel are available in the
Output
bar.
Note:
Whenever an output window is open, you can open the
Properties
window with the ALT-ENTER key combination, or with the right mouse button and the context menu.
You can then make different adjustment to the outputs here.
The
Overview
icon is used to show a results overview for each regulating step calculated.
This contains a summary of all the calculated measurement ranges with all the relevant lighting engineering results.
Results overview
When the results overview is open, you can use the ALT-ENTER key combination to open the
Properties
window.
You can now select with a tick which lighting engineering values are to be specified.
Properties window in the results overview
The output toolbar is used to output the calculated illuminances and luminance in
table form
for all the regulating steps that have been calculated.
Results table
You can use the icon to have the luminance curve isoline shown on a graph for each regulating step calculated.
The red curve is the target curve and the blue curve the actual curve.
Luminance curve
When the luminance curve is displayed, you can use the ALT-ENTER key combination to open the
Properties
window.
You can now make various adjustments to the output, such as having the curve displayed on a logarithmic scale.
You can also have the curve displayed in such a way that it starts just before the measurement range at the tunnel entrance.
Deviations
between actual curves and target curves can be shown in colour (with
green signifying above the target curve and red below it).
It is also possible to have all the luminance curves of the calculated regulating steps shown on a diagram.
Properties
window of the luminance curve
The
output toolbar is used for outputting the calculated illuminances and
luminance, for all the regulating steps that have been calculated, on a
diagram with pseudo colours.
Display in pseudo colours
Further outputs on the tunnel are available in the
Output bar
.
Under the project data, the data on the tunnel geometry and the calculation specifications are shown.
Output of the project data
In
the luminaire list, all the data is given separately for the adaptation
and interior zones and for the individual row of luminaires.
Details
are included of the luminaire types used, the overall number of
luminaires, the system power and the flicker frequency (only with a
constant luminaire spacing).
The
luminaire list contains the x-coordinates, the power step, the lamp
luminous flux, the control group and the luminous fluxes in the
individual regulating steps for all the luminaires.
Note:
The
calculated system power is based on the data for the installed power of
the luminaires that have been read in and must be checked there to
ensure that it is correct.
Output of the luminaire list